What are the installation steps of the lamp holder？

1. Put the installed lamp cap on the plastic sleeve, and then insert it into the clip hole on the table lamp clip, put on the washer, and then fix the metal hose and the table lamp clip firmly with screws.

2. Strip the insulating layer at the end of the power cord, and then install the power plug.

3. Use a multimeter to set the switch to the R×1 range of the resistance, and set it to zero. Connect the red and black watch sticks to the two pins of the power plug. If the resistance is zero, it means that there is a short-circuit fault inside, which should be eliminated immediately.

4. Use a multimeter to set the switch to R×10, and set it to zero. Contact the meter rod with the metal hose, and the other meter rod with the two pins of the power plug. If the pointer is zero or has a certain range, there is a short circuit or path between the metal hose and the power cord. If there is an unsafe problem, Check the fault immediately.a lamp holder is an example of

What are the brands of lamp holders? There are many brands of lamp holders, and lamp holders are small accessories, which are mostly used together with bulbs and so on. What are the installation steps of the lamp holder? When installing the lamp holder, you must give it to a professional electrician. If you do not hand it to the electrician, you will naturally be unable to guarantee the safety of the installation.

Guangzhou Gaaye Electronics Co., Ltd

www.gaaye.com