How to connect lampholders, lampholders？

Lampholder wiring is a work that we will encounter in our average family, but do we know how lampholder wiring is true? Let's take a look at it below.

1) First and foremost, we must prepare things for the connection of lamp sockets. There must be no shortage of wires. There are also electric lights, screwdrivers, lamp holders, strippers, tapes, and so on. Of course, in terms of wires, we generally use 1.2 square wire. If it is not just linking single lights, but also connecting electrical appliances, we recommend that we consider using 2.5 wires. The quality of the lights should be better. The same goes for light bulbs.

2) We need to peel off the thread with a wire stripper. This is based on our own needs. It is generally about one centimeter. Take care not to take too long at the time of stripping, otherwise it would be wasteful if it is not good to operate. If it is short, it must be inconceivable and inconvenient. This may cause problems. Because the blade of the wire stripper is very fast, we must pay attention not to break the copper wire when we strip the wire. Let's not let the wire be exposed to the outside, so that it is possible to have power. We need to open the lamp and connect the line with the corresponding positive and negative electrodes inside. The general lamp will have instructions for use. We can slowly follow the drawings.

3) Check the corresponding connection, no problem can fix the screw. We must ensure that the screws must be tightly closed to avoid loosening, and then we need to check whether the connected threads on the sides are connected. If so, we must deal with them. Regarding the situation of excessive stripping outside the line, we need to use tape to wrap it so that it will not be slack.

4) After the lamp is assembled, install a good lamp, and then turn on the electricity to see if it is bright. If it can be proved by normal light, it is now correctly connected.

Lampholder connection method

1) Flat lamp socket connection

The flat lamp holder generally has two wiring posts above it, one is connected with the neutral line of the power supply, and the other is a (phase) connection from the switch. At this time we can plug the two wiring posts on the flat lamp holder. The above two wire ends can be arbitrarily connected. The two wiring posts on the screw base flat lamp holder must have the power neutral wire heading for safety. Connected to the connecting pile of the connecting thread ring, the connecting wire end from the switch is connected to the connecting pile of the central reed.

2) Pendant lamp socket connection

Chandelier lampholders must use two textured plastic cords or braided wires as the connector for the terminal box. Both ends should be stripped of the insulating layer, put the upper end of the plastic cord into the hole in the cover box, make a knot, so that it can accept the weight of the pendant. Then separate the two ends of the cord from the two side holes of the central convex part of the box, and then connect them to the two wiring posts and cover the cable box cover. Then, the lower end of the plastic cord is put into the hole of the pedestal lamp holder, and a knot is also made. The two thread ends are then connected to the two wiring piles on the pendant lamp holder, and the chandelier lamp holder cover is covered.

Summary: Lampholders should be owned by every household. In the general condition of our home decoration, there is no need for electric lamp socket connection devices, so we briefly introduced the lampholder connection method to our home. , About lamp socket wiring device should be very careful, can not have the slightest effect, otherwise it will affect the future use of oh.

Guangzhou Gaaye Electronics Co., Ltd

www.gaaye.com